Registration = 10€

For your registration to our newsletter you will receive a 10 € voucher as a thank you.2

(In accordance with the data protection declaration, please send me regular and revocable information on the following product range by e-mail: Bicycles, fitness equipment and bicycle accessories)

Instagram Second Quality Bikes E-Bike ab 1099 €

Assembly instructions for children's bikes or 26 inch mountain bikes

1. Open carton

1. Open carton

Open the top of the box by carefully cutting the adhesive strips and removing the clamps.

Attention! Never cut the carton with a knife. You could damage the wheel or parts.

2. Remove wheel

2. Remove wheel

Remove the complete wheel and the accessory box. Put the tool (not included), the quick-releases and the pedals from the accessory box on the side so that they are ready to hand.

3. Unpack the handlebars

Unpack the handlebars, turn the fork in the direction of travel and mount the handlebars on the stem, making sure that the cables are correctly routed. For carbon parts, observe the prescribed tightening torques according to the manufacturer's instructions.


4. Insert front wheel

4. Insert front wheel

For disc brakes, remove the transport lock. For V-brake brakes, unhook the brake cable. For Magura-HS brakes, release the brakes using the cocking lever, following the Magura operating instructions.

Remove the transport lock of the fork and insert the front wheel straight and exactly to the stop into the dropouts and close the quick-release firmly (lever on the left in driving direction), observing the running direction of the tyre.

5. Insert saddle

5. Insert saddle

Now you can remove the remaining packaging material from the wheel. Loosen the seat post clamp on the seat tube and insert the seat post straight into the seat tube without turning.

6. Screw on the pedals

6. Screw on the pedals

Please screw pedals into the crank. The left crank has a left-hand thread and the matching pedal is marked with an “L” on the axle. The right crank has a righthand thread and the matching pedal is marked with an “R” on the axle. Both pedals have to be tightened with a 15 mm wrench (approx. 35 Nm).

Attention! never swap the left and right pedals.

7. Test drive

7. Test drive

Check the tire pressure. Refer to the operating instructions for the correct tyre pressure and then take a test drive.

Please follow the operating instructions

Important! Read the instruction manual carefully before using your bike for the first time. Pay particular attention to the instructions for maintenance and care of the bike.