Bike and e-bike assembly – Step-by-step instructions

Remove the cable ties

Remove protective components

Remove front protective caps

Remove rear protective caps

Unscrew the stem

Open the stem with a 5 mm Allen key to be able to remove the handlebar clamp.

Insert the handlebars

Centre the handlebars.

Align the handlebars centrally

Tight the stem

Fit the handlebar clamp and tighten all four bolts evenly and firmly.

Remove the transport lock

Remove fork guard

If necessary: Insert front wheel

Insert the front wheel straight, exactly to the stop, into the dropouts and tighten the quick release or thru axle. Pay attention to the running direction of the tire.

Insert the saddle

Loosen the seat post clamp on the seat tube. Insert the seat post straight into the seat tube without twisting.

Pedals Marking

Each pedal has a small mark(L and R) indicating on which side of the wheel the pedal should be mounted. The markings can be in different places.

Attention! Do not mix up the left and right pedals. Please read the information sheet.

Fit the left pedal

The left pedal has a left-hand thread. Tighten the pedal firmly with a 15 mm open-end spanner to approx. 35 Nm.

Fit the right-hand pedal

The right-hand pedal has a right-hand thread. Tighten the pedal with a 15 mm spanner to approx. 35 Nm.

Test drive

Take the correct tyre pressure from the operating instructions and check the tyre pressure. Afterwards, please do a test drive and tighten the pedals again.